The CarCapsule

Q.) If I put my car away wet, what will happen?
A.) The CarCapsule is an evaporative system. The constant air change will evaporate all moisture in a matter of hours. This will prevent rust from the exterior parts while eliminating mold and mildew from the interior.

Q.) Should I leave the windows up or down inside the CarCapsule?
A.) You should leave the windows either down all the way or at least half the way down. If you have a convertible the top should be put up so that it will not trap moisture in the compartment it is stored in. This will let the air circulate throughout the interior keeping it dry and odor free.

Q.) How much room does the CarCapsule take up?
A.) Once inflated, the CarCapsule takes up about 1 foot on either side of the vehicle. The front and back depend on what size CarCapsule is used.

Q.) How do you get the vehicle in the CarCapsule?
A.) The CarCapsule uses two zippers that run around the base mat to the back where the fan is located. Just unzip and roll the upper shroud towards the fan. Pull the vehicle on to the base mat and roll the upper shroud over the vehicle. Zip up the unit and plug in the fan. The CarCapsule takes about 5-10 minutes to inflate.

Q.) What happens if I get a hole in it?
A.) The upper shroud is made of 10 mil PVC. If you do happen to puncture the unit, the manufacturer recommends that you repair the damage with a piece of clear 100% PVC shipping tape. This will bond to the upper shroud and will not come off.

Q.) What if the power goes out?
A.) The cover will deflate and turn into a regular car cover. When the power returns it will re-inflate in a matter of minutes. We do have a cigarette lighter adapter cord that can be run off of a 12 volt power supply for prolonged power disruptions or for use at car shows.

Q.) Do you have a CarCapsule that will fit my pick-up truck?
A.) Yes, but we recommend that you verify the height of your truck and compare it with the heights listed (see the Size Info tab, above).

Q.) Do you need to use another cover with the CarCapsule?
A.) You do not need to use another cover with the CarCapsule. This will only block air from circulating in the interior and might trap moisture.

Q.) Can the CarCapsule be used for short-term storage?
A.) The CarCapsule can be used for short-term, long-term or anything in between. It takes about the same time to use as a regular car cover except for the inflating of the unit. This takes just minutes.

• Base mat is made from a laminated fabric
• Flame retardant materials
• Mildew and rot resistant
• Upper shroud is 10-mil PVC, clear double polished and radio-welded
• High-pressure 12-volt fan produces 50CFM of volume
• Scratch-resistant zipper is 100% nylon

1. Place the CarCapsule on a flat surface, with the fan end near a power source, in a location that gives you access to the zippers. The intake should be away from outside doors and heat sources (note that the CarCapsule is for indoor use only).
2. Insert the fan panel into position, smoothing out the Velcro.
3. Push the male connector through the slit in the basemat. Connect the male end to the female end connector of the fan motor.
4. Starting at the fan end, carefully drape the clear center section over the vehicle's hood, roof and trunk. Zip both zippers closed to secure the tops and sides.
5. Plug the 12V transformer into your wall outlet and your CarCapsule will start to inflate. After the bubble is completely inflated, insert the filter by pushing the brim inside the flap around the fan.

Sizes available:

8-foot, for motorcycles (8'L x 32"W x 54"H):

• Standards, sportbikes, cruisers, most sport touring bikes

• Touring bikes, large customs, choppers

• MG TC, Mazda Miata, MGB, Alfa Romeo Giulietta Spider, original VW Beetle, etc.

• Porsche 911, Jaguar E-Type & XK120, Mercedes 280SL, early Mustangs, etc.

• Camaro, BMW 2800CS, Corvette Stingray, '57 Chevy, most musclecars, etc.

• 1959 Cadillac Eldorado, Rolls-Royce Silver Shadow, Dodge Viper*, Ferrari 360 Modena*, etc.

Note: please measure your vehicle to be sure to get the correct fit. Allow room on the ends and sides for extra breathing space.

*These cars are "bumped-up" in size due to their width.